Bartec MC 9090ex-S Manuel d'utilisateur télécharger pdf (Page 42)

Additional Components

7. Snap on the keypad in the direction of the arrow (see fig. 4) and push it upwards until the boreholes for

the screws are over the threaded sleeves.

Fig. 4: Changing the keypad

8. Check that the keypad is mounted correctly.

Figure 5: Keypad mounted correctly Figure 6: Keypad mounted incorrectly

9. Tighten the screws (torque = 0.565 Nm / torque = 5.0 in-lbs), 0.5 Nm advisable

Caution: The torque must be adhered to.

10. After the exchange of the keyboard a cold boot (see chapter 5.5 "Warm Boot and Cold Boot ")

must be performed.

The current drivers of the new keyboard are initialized by the cold boot.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 71 72

Pas de commentaire

Bartec MC 9090ex-S Manuel d'utilisateur Page 42